Yamaha® Nitro Installation

A blue Yamaha® snowmobile on snow in a forest.

Yamaha® Nitro Installation

Did you know that many snowmobile tunnel extensions can be installed at home? Our team at Tracks USA strives to be your go-to resource for all things snowmobile tracks! Continue reading for a breakdown of how to install your Yamaha® Nitro extensions. If you have any additional questions, you can give us a call or visit us in Lake Lillian, MN.

Tunnel Preparation:

  1. Remove rear bumper, snow flap, plastic cover around exhaust, as well as tunnel end cap. Loosen tail light from tunnel and allow to hang out of the way.
  2. You now have a blank rear tunnel ready to accept the tunnel extension.

Installation Procedure:

  1. Begin by placing the tunnel extension inside of your existing tunnel. You will notice pilot holes placed in the tunnel extension that will line up with holes already existing in your tunnel. You can place the 3/16” rivets in several holes to assure alignment prior to actually attaching the extension.
  2. Once aligned, clamp the tunnel extension in place and place a rivet in all the holes pre-existing in both your tunnel and tunnel extension.
  3. After tunnel extension is in place, take the tunnel end cap and place in tunnel extension and rivet in place.
  4. Once the tunnel extension / end cap are riveted into place, you can reattach your snow flap, bumper and tail light. The tail light will remain in stock location unless you have decided to purchase our tail light wiring extension and are going to relocate it toward the back of the tunnel.
  5. After installation of tunnel extension is complete, you can now reattach all plastic facia around your exhaust exit / rear of seat.

Tracks USA

Please feel free to contact us or stop in today! Call us at (320) 382-6128 or contact us below.